Руководство Пользователя для Cisco Cisco Content Security Management Appliance M160
14-9
AsyncOS 8.1 for Cisco Content Security Management User Guide
Chapter 14 Common Administrative Tasks
Availability of Services During Backups
Backing up a Security Management appliance copies the active data set from the ‘source’ Security
Management appliance to a ‘target’ Security Management appliance with minimum disruption on the
originating ‘source’ appliance.
Management appliance to a ‘target’ Security Management appliance with minimum disruption on the
originating ‘source’ appliance.
The phases of the backup process and their effect on the availability of services are as follows:
•
Phase 1—Phase 1 of the backup process starts with the data transfer between the source and target
appliances. During data transfer, services on the source appliance remain running, therefore data
collection can still continue. However, services are shut down on the target appliance. Once the data
transfer is complete from the source to target appliance, Phase 2 begins.
appliances. During data transfer, services on the source appliance remain running, therefore data
collection can still continue. However, services are shut down on the target appliance. Once the data
transfer is complete from the source to target appliance, Phase 2 begins.
•
Phase 2—When Phase 2 begins, services on the source appliance are shut down. Any differences
that have collected during the data transfer between the source and target appliance since the initial
shutdown are copied to the target appliance and the service is brought back up for both the source
and the target. This allows maintain maximum uptime on the source appliance and no data loss for
either appliance.
that have collected during the data transfer between the source and target appliance since the initial
shutdown are copied to the target appliance and the service is brought back up for both the source
and the target. This allows maintain maximum uptime on the source appliance and no data loss for
either appliance.
During the backup, data availability reports may not work, and when viewing the message tracking
results, the hostname for each message may be labeled as ‘unresolved’.
results, the hostname for each message may be labeled as ‘unresolved’.
If you try to schedule a report and forget that a backup is in progress, you can check the system status
by choosing Management Appliance > Centralized Services. From this window you can see the
warning that a system backup is in progress:
by choosing Management Appliance > Centralized Services. From this window you can see the
warning that a system backup is in progress:
Interruption of a Backup Process
Note
If there is an unexpected reboot of the source appliance while a backup is being performed, the target
appliance is unaware of this stoppage. You must cancel the backup on the target appliance.
appliance is unaware of this stoppage. You must cancel the backup on the target appliance.
If there is an interruption of the backup process and the backup process is not completed, the next time
a backup is attempted, the Security Management appliance can start the backup process up from where
it was stopped.
a backup is attempted, the Security Management appliance can start the backup process up from where
it was stopped.