Руководство Пользователя для Cisco Cisco Content Security Management Appliance M160

2-5

AsyncOS 8.1 for Cisco Content Security Management User Guide

Chapter 2 Setup, Installation, and Basic Configuration

For more information, see

Appendix B, “Assigning Network and IP Addresses.”

Note

If you are running a firewall on your network between the Internet and the content security appliance, it
may be necessary to open specific ports for the appliance to work properly. For more information on
firewalls, see

Appendix C, “Firewall Information.”

Note

Always use the same IP address on the Security Management appliance for receiving and sending email
messages to the Email Security appliances. For an explanation, see information about Mail Flow in the
documentation for your Email Security appliance.

Gathering the Setup Information

Use the following table to gather information about system setup. You will need this information at hand
while running the System Setup Wizard.

Note

See the

Appendix B, “Assigning Network and IP Addresses,”

for detailed information about network and

IP addresses.

Table 2-1

System Setup Worksheet

Notifications

Email address where system alerts are sent:

System Time

NTP Server (IP address or hostname):

Admin Password

Choose a new password for the “admin” account:

AutoSupport

Enable Cisco IronPort AutoSupport?___ Yes ___ No

Hostname

Fully qualified hostname of the Security Management
appliance:

Interface / IP Address

IP address:

Netmask:

Network

Gateway

Default Gateway (router) IP address:

DNS

___ Use the Internet’s root DNS servers

___ Use these DNS servers: