Руководство По Устранению Ошибки для Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP)
Conversion of a Point−to−Point (1+1)
Configuration to a Two−Fiber BLSR
Configuration to a Two−Fiber BLSR
Document ID: 63654
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Convert Point−to−Point (1+1) to BLSR
Related Information
Related Information
Introduction
This document describes the procedure to upgrade a point−to−point (1+1) configuration (with two nodes) to a
two−fiber bidirection line switched ring (BLSR) in an ONS 15454 network.
two−fiber bidirection line switched ring (BLSR) in an ONS 15454 network.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
CISCO ONS 15454
•
Components Used
The information in this document is based on these software and hardware versions:
CISCO ONS 15454 version 4: All
•
CISCO ONS 15454 version 3: 3.3.0 and later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Background Information
This document uses a lab setup with two nodes (Node1 and Node2) (see Figure 1).
Figure 1 Topology