Руководство Пользователя для Cisco Cisco Content Security Management Appliance M1070
14-11
AsyncOS 8.2 for Cisco Content Security Management User Guide
Chapter 14 Common Administrative Tasks
Note
A backup process will not start if there are any ongoing backups on the remote machine.
Procedure
Step 1
Login, as administrator, to any SSH session.
Step 2
At the command prompt, type backupconfig and press Enter.
Choose the operation you want to perform:
•
View — Allows you to view the scheduled backups.
•
Verify — Verifies if the backup can be scheduled to a remote machine.
•
Schedule — Allows you to schedule a backup to an appliance.
•
Cancel — Cancels a scheduled backup.
•
Status — Allows you to view the status of the ongoing back up in progress.
•
Setup - Configure backup parameters.
Step 3
If the connection between source and target appliances is slow, turn on data compression:
Type setup and enter Y.
Step 4
Type Schedule and press Enter.
Step 5
Type the IP address of the target Security Management appliance.
Step 6
Enter a meaningful name to identify the target appliance (up to 20 characters).
Step 7
Enter the admin user name and password for the target appliance.
Step 8
Respond to prompts about which data you want to back up.
The Security Management appliance now verifies the existence of the target machine, and determines
whether the target machine has enough space to accept the data.
whether the target machine has enough space to accept the data.
If the space on the target machine is not sufficient, the following error message is generated
“Backup
cannot be scheduled. Reason: There is not enough space for Spam Quarantine, Email
Tracking, Web Tracking, Reporting. Please increase disk allocation for these services on
the target machine.”
and data is not transferred.
Once the target machine is verified, the following choices appear on the console:
1. Setup Reoccurring Backup—allows you schedule a periodic backup.
2. Schedule a Single backup—allows you to schedule a single backups.
3. Start a Single Backup Now—allows you to initiate an immediate backup.
Step 9
Type 3 and press Enter.
Step 10
Enter a meaningful name for the backup job.
The backup process begins in a few minutes, and data starts transferring from the source machine to the
target machine. After an immediate backup has started, the following message can be seen:
target machine. After an immediate backup has started, the following message can be seen:
“Backup has
been initiated and will begin in a few seconds.”
Step 11
(Optional) To see the progress of the backup, type Status at the command-line prompt.
Step 12
See also
.