Техническая Инструкция для Cisco Cisco ASA 5545-X Adaptive Security Appliance - No Payload Encryption
ASDM 6.4: Site−to−Site VPN Tunnel with IKEv2
Configuration Example
Configuration Example
Document ID: 113486
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
ASDM Configuration on HQ−ASA
Verify
Troubleshoot
Troubleshooting Commands
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
ASDM Configuration on HQ−ASA
Verify
Troubleshoot
Troubleshooting Commands
Related Information
Introduction
This document describes how to configure a site−to−site VPN tunnel between two Cisco Adaptive Security
Appliances (ASAs) using Internet Key Exchange (IKE) version 2. It describes the steps used to configure the
VPN tunnel using an Adaptive Security Device Manager (ASDM) GUI wizard.
Appliances (ASAs) using Internet Key Exchange (IKE) version 2. It describes the steps used to configure the
VPN tunnel using an Adaptive Security Device Manager (ASDM) GUI wizard.
Prerequisites
Requirements
Make sure that the Cisco ASA has been configured with the basic settings.
Components Used
The information in this document is based on these software and hardware versions:
Cisco ASA 5500 Series Adaptive Security Appliances running software version 8.4 and later
•
Cisco ASDM software version 6.4 and later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.