Примечания к выпуску для Cisco Cisco 4404 Wireless LAN Controller
2
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.2.206.0
OL-31336-01
Cisco Unified Wireless Network Solution Components
Cisco Unified Wireless Network Solution Components
The following components are part of the Cisco UWN Solution and are compatible in this release:
•
Software release 4.2.206.0 for all Cisco controllers and lightweight access points
•
Cisco autonomous to lightweight mode upgrade tool release 3.0
•
Cisco Wireless Control System (WCS) software release 4.2.128.0, 5.2, or 6.0
Note
Only Cisco WCS 4.2.128.0, 5.2, and 6.0 support controllers running software release
4.2.206.0.
4.2.206.0.
•
Cisco WCS Navigator 1.1.110.0
•
Location appliance software release 3.1.43.0
•
Cisco 2700 Series Location Appliances
•
Cisco 2000 Series Wireless LAN Controllers
•
Cisco 2100 Series Wireless LAN Controllers
•
Cisco 4400 Series Wireless LAN Controllers
•
Cisco Wireless Services Module (WiSM) for Cisco Catalyst 6500 Series Switches and Cisco 7600
Series Routers
Series Routers
•
Cisco Wireless LAN Controller Network Module for Cisco Integrated Services Routers
•
Catalyst 3750G Wireless LAN Controller Switches
•
Cisco 3201 Wireless Mobile Interface Card (WMIC)
•
Cisco Aironet 1000, 1100, 1130, 1200, 1230AG, 1240, 1250, and 1300 Series Lightweight Access
Points
Points
Note
Only Cisco Aironet 1200 Series Access Points that contain 802.11g (AIR-MP21G) or
second-generation 802.11a radios (AIR-RM21A or AIR-RM22A) are supported for use with
controller software releases. The AIR-RM20A radio, which was included in early 1200
series access point models, is not supported. To see the type of radio module installed in your
access point, enter this command on the access point: show controller dot11radio n, where
n is the number of the radio (0 or 1).
second-generation 802.11a radios (AIR-RM21A or AIR-RM22A) are supported for use with
controller software releases. The AIR-RM20A radio, which was included in early 1200
series access point models, is not supported. To see the type of radio module installed in your
access point, enter this command on the access point: show controller dot11radio n, where
n is the number of the radio (0 or 1).
Special Notice for Mesh Networks
Note
Do not upgrade to controller software release 4.2.206.0 if you have mesh access points in your network.
If your network uses mesh access points, use only mesh-specific releases. These releases are labeled
MESH in the Software Center.
If your network uses mesh access points, use only mesh-specific releases. These releases are labeled
MESH in the Software Center.
Note
Cisco WCS software release 4.2.128.0 may be used to manage both mesh and non-mesh controllers
(such as controllers running software release 4.2.206.0 and 4.1.192.35M). You do not need different
instances of WCS to manage mesh and non-mesh controllers.
(such as controllers running software release 4.2.206.0 and 4.1.192.35M). You do not need different
instances of WCS to manage mesh and non-mesh controllers.