Примечания к выпуску для Cisco Cisco Prime Infrastructure 1.3
Update 4 for Cisco Prime Infrastructure 1.3.0.20
Page 3
Installation Guidelines
Caution: You cannot uninstall or remove this patch.
Notes:
It is important to back up your system before applying this patch. Store the
backup in an external repository. This will help you to revert to the original Prime
Infrastructure 1.3.0.20 state. For details, see the “Reverting to the Original Prime
Remove high availability (from both primary and secondary servers) before
performing the upgrade.
If you have installed Update-4 newly or upgraded to Update-4 from Prime
Infrastructure 1.3.0.20 on your secondary server, the installation or upgrade will
stop as part of the application start-up. To fix this issue, you need to open another
admin console and run the Update-4 patch installation to address this issue.
There is no need to shut down your server before installing this patch release. The
patch installation will stop the application and restart it again.
There is no need to reboot your system manually after applying this patch.
The patch installation takes approximately 15-20 minutes.
Follow these steps to install Update 4 for Cisco Prime Infrastructure 1.3.0.20 to your existing
Prime Infrastructure 1.3.0.20 system or Update 1 for Cisco Prime Infrastructure 1.3.0.20:
Prime Infrastructure 1.3.0.20 system or Update 1 for Cisco Prime Infrastructure 1.3.0.20:
Step 1
Go to the following URL to download the PI_1_3_0_20-Update.4-16.tar.gz patch
to your repository:
to your repository: