Руководство По Обслуживанию для Cisco Cisco Unified MeetingPlace Audio Server
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
5-28
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing the hot swap controller
Step 3
Press the ejector levers outward. This partially unseats the hot swap controller transition module from
the backplane connectors. See Figure 5-18.
the backplane connectors. See Figure 5-18.
Step 4
Pull the hot swap controller transition module from the chassis by pressing the ejector levers outward
and pulling the hot swap controller transition module out. See Figure 5-18.
and pulling the hot swap controller transition module out. See Figure 5-18.
Installing the new hot swap controller transition module
Step 1
Press the ejector levers outward. See Figure 5-19.
Step 2
Holding the hot swap controller transition module by the levers, partially insert it into the slot, about half
way.
way.
Step 3
Verify that the hot swap controller transition module is properly seated in the guides, top and bottom. If
not, remove it and try again.
not, remove it and try again.
Step 4
Pushing gently and firmly on the hot swap controller transition module’s face plate, slide it into the slot
until you encounter significant resistance. At this point, the levers should be in contact with the chassis
rails so they will grab when pushed inward.
until you encounter significant resistance. At this point, the levers should be in contact with the chassis
rails so they will grab when pushed inward.
Step 5
Use the ejector levers to seat the hot swap controller transition module in the slot by closing the levers
toward one another until they are in the horizontal locked position. See Figure 5-19.
toward one another until they are in the horizontal locked position. See Figure 5-19.
Step 6
Secure the hot swap controller transition module by tightening the captive screws at the top and bottom
of the panel. See Figure 5-19.
of the panel. See Figure 5-19.
Step 7
Verify that any empty slots have covers on them.
Warning
An empty slot that is uncovered can result in a destructive hardware failure.
Step 8
Attach the power cable to the back of the server.
Step 9
Power up the server. Refer to the “Powering up the server” section on page 4-17.
Testing the hot swap controller
Step 1
Verify the hot swap controller card’s ejector levers are locked. If the LED on the bottom of the hot swap
controller card is blue, the hot swap controller card is not locked. If the hot swap controller card is not
locked, reseat it.
controller card is blue, the hot swap controller card is not locked. If the hot swap controller card is not
locked, reseat it.
Step 2
Verify the hot swap controller transition module’s levers are locked. If the LED on the bottom of the hot
swap controller card is blue, the hot swap controller transition module is not locked. If the hot swap
controller transition module is not locked, reseat it.
swap controller card is blue, the hot swap controller transition module is not locked. If the hot swap
controller transition module is not locked, reseat it.
Step 3
Test the installation by following the procedure in the
.