Руководство По Обслуживанию для Cisco Cisco Unified MeetingPlace Audio Server
7-7
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 7 Installing a Shadow Server
Preparing to configure the shadow server
Step 6
Click
Save Changes
in the bottom right corner.
Step 7
Log out and close MeetingTime.
Restarting the primary server
The primary server must be restarted at this point. This restart should have been previously scheduled
with the customer.
with the customer.
Step 1
If not already connected, access the command line interface (CLI) by following the procedures in the
and
.
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
Type
restart enable
and press Enter. The system prompts you to verify you really want to restart the
server.
Step 4
Type
y
and press Enter to confirm. The primary server restarts.
Backing up the primary server’s database
The primary server’s database should be backed up at this point.
The backup mechanism has changed in this version of MeetingPlace Audio Server. It is now done
through the MeetingPlace Backup Gateway. For information on how to install, configure, and use the
backup gateway, refer to the MeetingPlace Backup Gateway System Manager’s Guide.
through the MeetingPlace Backup Gateway. For information on how to install, configure, and use the
backup gateway, refer to the MeetingPlace Backup Gateway System Manager’s Guide.
Preparing to configure the shadow server
This section explains the steps necessary before the shadow server can be configured.
Step 1
Power on the shadow server by flipping the power switch to the on (“|”) position. The power switch is
located on the back of the server in the bottom left corner. See
located on the back of the server in the bottom left corner. See