Руководство По Установке для Cisco Cisco 1 GHz GainMaker Amplifier
Chapter 3 Balancing and Setup
To Set Switch S1 for Amplifier and Coax Compensation Mode
You must set switch S1 to position number 3 to use amplifier and coax compensation
You must set switch S1 to position number 3 to use amplifier and coax compensation
mode.
To Determine the Output Tilt
Complete the following steps to determine the output tilt of the amplifier.
1 Connect the test point adapter to the forward main output test point.
Complete the following steps to determine the output tilt of the amplifier.
1 Connect the test point adapter to the forward main output test point.
2 Consult the design print to find the proper output tilt.
3 Measure the output signal levels at the frequencies you used in
3 Measure the output signal levels at the frequencies you used in
To Verify the
Input Signal Level (on page 49).
4 To determine the actual output tilt, calculate the difference (in dB) between the
levels of the lowest and highest specified frequencies.
5 Proceed to the next section, To Set the Output Tilt.
68
OL-31156-01