Технические ссылки для Cisco Cisco TelePresence MX700

D15335.04

 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.2, JUNE 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

29

Cisco TelePresence MX700 and MX800

API Reference Guide

Telnet

Telnet can be viewed as the equivalent of the serial protocol 

in the TCP/IP world. Telnet is disabled by default. Before 

connecting to the codec with Telnet you have to enable it.

Codec configuration

To enable Telnet service, configure the following setting on 

the codec. Changing this setting does not require a reboot of 

the device, but it may take some time to take effect.

xConfiguration NetworkServices Telnet Mode: On

SSH

SSH is a secure TCP/IP connection and it is enabled by 

default on the codec. It can be disabled. You need a SSH 

client, such as PuTTY, to access the API over SSH.

HTTP/HTTPS

As HTTP/HTTPS are connectionless protocols, there is no 

persistent connection. There are several ways of communi-

cating with the API over HTTP.

Codec configuration
In order to enable or disable the HTTP and HTTPS services, 

configure the following settings on the codec. 

xConfiguration NetworkServices HTTP Mode: 

<Off/On>

xConfiguration NetworkServices HTTPS Mode: 

<Off/On>

Connecting

You can inspect the API by entering the IP address or 

host name of the codec in your favorite web browser. In 

the web interface, you can find the API documents under 

the menu section 

. The HTTP 

POST and GET methods are used to execute commands 

and get feedback from the codec. This is described in 

 in this document.

Introduction

About the API

xConfiguration

Appendices

xCommand

xStatus



About the API