Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.03 MX Series Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

58

The Standby settings

Standby Control

Determine whether the system should go into standby mode or not.
Requires user role: ADMIN
Value space: <On/Off>

On: Enter standby mode when the Standby Delay has timed out. NOTE: Requires the Standby 

Delay to be set to an appropriate value.
Off: The system will not enter standby mode.

Example: Standby Control: On

Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby mode. 

NOTE: Requires the Standby Control to be enabled.
Requires user role: ADMIN
Value space: <1..480>

Range: Select a value from 1 to 480 minutes.

Example: Standby Delay: 10

Standby BootAction

Define the camera position after a restart of the codec.
Requires user role: ADMIN
Value space: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/
Preset7/Preset8/Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/

Preset15/RestoreCameraPosition/DefaultCameraPosition>

None: No action.
Preset1 to Preset15: After a reboot the camera position will be set to the position defined by 

the selected preset.
RestoreCameraPosition: After a reboot the camera position will be set to the position it had 

before the last boot.
DefaultCameraPosition: After a reboot the camera position will be set to the factory default 

position.

Example: Standby BootAction: DefaultCameraPosition

Standby StandbyAction

Define the camera position when going into standby mode.
Requires user role: ADMIN
Value space: <None/PrivacyPosition>

None: No action.
PrivacyPosition: Turns the camera to a sideways position for privacy.

Example: Standby StandbyAction: PrivacyPosition

Standby WakeupAction

Define the camera position when leaving standby mode.
Requires user role: ADMIN
Value space: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/
Preset7/Preset8/Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/

Preset15/RestoreCameraPosition/DefaultCameraPosition>

None: No action.
Preset1 to Preset15: When leaving standby the camera position will be set to the position 

defined by the selected preset.
RestoreCameraPosition: When leaving standby the camera position will be set to the position 

it had before entering standby.
DefaultCameraPosition: When leaving standby the camera position will be set to the factory 

default position.

Example: Standby WakeupAction: RestoreCameraPosition

Introduction

Table of contents

Web interface

Advanced settings

Appendices

Advanced settings