Листовка для Cisco Cisco 6015 IP DSL Switch

"Dialer0" has an IP address of 172.18.0.1 and a subnet mask of 255.255.0.0. NAT is configured for outside.
This means that the interface is connected to an outside network, such as the Internet.

Before you attempt this configuration, ensure that you meet these requirements. To support the ADSL WIC on
the Cisco 2600/3600, thishardware is required:

2600: Chassis WIC slots, NM−2W

• 

3600: NM−1FE1R2W, NM−1FE2W, NM−2FE2W, NM−2W

Note: For the Cisco 3600, t these donot support the ADSL WIC: NM−1E1R2W, NM−1E2W,
NM−2E2W.

• 

To support the ADSL WIC, these Cisco IOS Software releases are required:

Cisco IOS Software Release 12.1(5)YB (Plus versions only) on the Cisco 2600/3600.

• 

Cisco IOS Software Release IOS 12.1(3)XJ or later (Plus versions or ADSL feature set only) on the
Cisco 1700. The ADSL feature set is identified by "y7" in the image name; for example,
c1700−sy7−mz.121−3.XJ.bin.

Note: When you download the image for the Cisco 1700, make sure you select the image name of
1700. Do not download a 1720 or a 1750 image. The features will not support the ADSL WIC.

• 

The information in this document is based on these software and hardware versions .

Cisco 6400 UAC−NRP IOS Software Release 12.1(3)DC1

• 

Cisco 6400 UAC−NSP IOS Software Release 12.1(3)DB

• 

Cisco 6130 DSLAM−NI2 IOS Software Release 12.1(5)DA

• 

The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

In this section, you are presented with the information to configure the features described in this document.

Note: To find additional information on the commands used in this document, use the Command Lookup
Tool (registered customers only) .