Руководство По Установке для Cisco Cisco Prime Infrastructure 2.1

flow record type performance-monitor PerfMonRecord

  match ipv4 protocol

  match ipv4 source address

  match ipv4 destination address

match transport source-port

  match transport destination-port

match transport rtp ssrc

collect application media bytes counter

  collect application media bytes rate

  collect application media packets counter

  collect application media packets rate

  collect application media event

  collect interface input

  collect interface output

  collect counter bytes

  collect counter packets

  collect routing forwarding-status

  collect transport packets expected counter

  collect transport packets lost counter

  collect transport packets lost rate

  collect transport round-trip-time

  collect transport event packet-loss counter

  collect transport rtp jitter mean

  collect transport rtp jitter minimum

  collect transport rtp jitter maximum

  collect timestamp interval

  collect ipv4 dscp

  collect ipv4 ttl

  collect ipv4 source mask

  collect ipv4 destination mask

  collect monitor event

flow monitor type performance-monitor PerfMon

  record PerfMonRecord

  exporter PerfMonExporter

flow exporter PerfMonExporter

  destination PrInIP

  source Loopback0

  transport udp PiInPort

policy-map type performance-monitor PerfMonPolicy

  class class-default

! Enter flow monitor configuration mode.

  flow monitor PerfMon

! Enter RTP monitor metric configuration mode.

  monitor metric rtp

!Specifies the minimum number of sequential packets required to identify a stream as being an RTP flow.

  min-sequential 2

! Specifies the maximum number of dropouts allowed when sampling RTP video-monitoring metrics.

  max-dropout 2

! Specifies the maximum number of reorders allowed when sampling RTP video-monitoring metrics.

  max-reorder 4

! Enter IP-CBR monitor metric configuration mode

  monitor metric ip-cbr

! Rate for monitoring the metrics (1 packet per sec)

  rate layer3 packet 1

interface interfacename

  service-policy type performance-monitor input PerfMonPolicy

  service-policy type performance-monitor output PerfMonPolicy

In this example configuration:

 is the IP address of the Prime Infrastructure server.

 is the UDP port on which the Prime Infrastructure server is listening for Medianet data (the default is 9991).

 is the name of the interface (such as GigabitEthernet0/0 or fastethernet 0/1) sending Medianet 

NetFlow data to the specified PrInIP.

For more information on Medianet configuration, see the