Листовка для Cisco Cisco Wireless LAN Controller Module

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Network Setup
 Configure
      Configure Dynamic Interfaces on the WLC for the Guest and Internal Users
      Create WLANs for the Guest and Internal Users
      Configure the Layer 2 Switch Port that Connects to the WLC as Trunk Port
      Configure the Router for the Two WLANs
 Verify
 Troubleshoot
      Troubleshooting Procedure
      Troubleshooting Commands
 Related Information

This document provides a configuration example for a guest wireless LAN (WLAN) and a secure internal
WLAN that use WLAN controllers (WLCs) and lightweight access points (LAPs). In the configuration in this
document, the guest WLAN uses web authentication to authenticate users and the secure internal WLAN uses
Extensible Authentication Protocol (EAP) authentication.

Ensure that you meet these requirements before you attempt this configuration:

Knowledge of how to configure the WLC with basic parameters

• 

Knowledge of how to set up a DHCP and Domain Name System (DNS) server

• 

The information in this document is based on these software and hardware versions:

Cisco 2006 WLC that runs firmware release 4.0

• 

Cisco 1000 Series LAP

• 

Cisco 802.11a/b/g Wireless Client Adapter that runs firmware release 2.6

• 

Cisco 2811 router that runs Cisco IOS® version 12.4(2)XA

• 

Cisco 3500 XL Series Switch that runs Cisco IOS version 12.0(5)WC3b

• 

DNS server that runs on a Microsoft Windows 2000 server

•