Белая книга для Cisco Cisco Prime Infrastructure 3.0

 

 

© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 

Page 40 of 83 

 

Deploying TNF is relatively simple, but FNF can be challenging. Cisco Prime Infrastructure greatly simplifies 

managing NetFlow end to end. You can follow the design, deploy, operate, report model for NetFlow as well. You 

can design the NetFlow template by going to Design > Configuration Templates > My Templates > OOTB > 

Collecting Traffic Statistics. This will open the NetFlow v9 templates as shown in the figure above. You can fill in 

all the metadata at the top of the template and save as a new template. The next step is to publish the template so 

that it becomes available for other members to deploy the template. Note that the default port for NetFlow for Cisco 

Prime Infrastructure 2.0 is 9991 and cannot be changed in this release. 

 

 TIP: 

 (Not tested nor supported by TAC) may be used to point all devices to send NetFlow to one 

place. Samplicator can then fork out NetFlow data to multiple Cisco Prime Infrastructure instances as desired. 

Samplicator can also be used for syslogs and traps in addition to Netflow.