Руководство По Устранению Ошибки для Cisco Cisco Content Switching Module
Upgrading the Catalyst 6500 Content Switch
Module Software
Module Software
Document ID: 5207
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Before Upgrading
Upgrading from the Supervisor Engine Bootflash
Upgrading from a PCMCIA Card
Upgrade the CSM from an External TFTP Server
Troubleshooting
Related Information
Prerequisites
Requirements
Components Used
Conventions
Before Upgrading
Upgrading from the Supervisor Engine Bootflash
Upgrading from a PCMCIA Card
Upgrade the CSM from an External TFTP Server
Troubleshooting
Related Information
Introduction
This document describes each of the three possible methods for upgrading the Content Switching Module
(CSM), including the following:
(CSM), including the following:
Upgrading from the Supervisor Engine Bootflash
•
Upgrading from a PCMCIA Card
•
Upgrading the CSM from an External TFTP Server
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Before Upgrading
All commands are entered on a console connected to the Supervisor.
1.
When performing the upgrade procedures, enter one configuration command per line.
2.
After completing the upgrade procedure, enter Exit to return to the Supervisor prompt.
3.
When upgrading to a new software release, you must upgrade the CSM image before upgrading the Cisco IOS
® software image. Failure to do so will cause the Supervisor Engine to not recognize the CSM. In this case,
® software image. Failure to do so will cause the Supervisor Engine to not recognize the CSM. In this case,