Примечания к выпуску для Cisco Headend System Release 2.7
Chapter 2 DNCS Pre-Upgrade Procedures
64
4019475 Rev D
12 Are any UI processes still running?
If yes, type kill -9 [PID] and then press Enter for any UI process that is still
running.
Note: Substitute the process ID of the running process for [PID].
running.
Note: Substitute the process ID of the running process for [PID].
If no, go to step 13.
13 Type showActiveSessions and then press Enter.
Result: One of the following messages appears:
A message indicating that the INFORMIXSERVER is idle
A message listing active database sessions
14 Did the message in step 13 indicate that there are active database sessions?
If yes, complete these steps:
a Type killActiveSessions and then press Enter. The system removes all
a Type killActiveSessions and then press Enter. The system removes all
active sessions from the database.
b Type showActiveSessions again and then press Enter.
c Did a message appear indicating that there are active database sessions?
c Did a message appear indicating that there are active database sessions?
If yes, call Cisco Services.
If no, go to step 15.
If no, go to step 15.
15 Type dncsKill and then press Enter. The system terminates the dncsInitd process
if it is still running.
16 Wait a few moments, and then type ps -ef | grep dncsInitd and press Enter.
The system reports whether the dncsInitd process is still running.
17 Is the dncsInitd process still running?
If yes, then repeat this procedure from step 15 until the process stops
running, then go to the installation procedures.
running, then go to the installation procedures.
If no, go to the installation procedures.