для Cisco Cisco Tunnel Terminating Gateway (TTG)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold aaa-auth-failure-rate
▄ Command Line Interface Reference, StarOS Release 18
5606
Usage
Authentication failure rate thresholds generate alerts or alarms based on the percentage of AAA
authentication message requests that failed during the specified polling interval. Authentication requests are
counted for all AAA authentication servers that the system is configured to communicate with.
Alerts or alarms are triggered for authentication failures based on the following rules:
authentication message requests that failed during the specified polling interval. Authentication requests are
counted for all AAA authentication servers that the system is configured to communicate with.
Alerts or alarms are triggered for authentication failures based on the following rules:
Enter condition: Actual failure percentage is greater than or equal to the high threshold.
Clear condition: Actual failure percentage is less than the low threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example
The following command configures a AAA authentication failure rate high threshold percentage of
30
for a
system using the Alert thresholding model:
threshold aaa-auth-failure-rate 30