Руководство По Установке для Cisco Cisco Web Security Appliance S670
9
6
Plug In the Appliance
Plug the female end of each straight power cable into the
redundant power supplies on the back panel of the appliance.
redundant power supplies on the back panel of the appliance.
Plug the male end(s) into an electrical outlet.
7
Temporarily Change Your IP
Address for Remote Access
To remotely configure the Cisco S390 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco S390, without changing the IP address. If
you use the serial console, proceed to section 8 below.
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco S390, without changing the IP address. If
you use the serial console, proceed to section 8 below.
Note
Make a note of your current IP configuration settings
as you will need to revert to these settings after you
finish the configuration.
as you will need to revert to these settings after you
finish the configuration.
For Windows
Step 1
Connect your laptop to the Management port using the
Ethernet cable included in the system box. The Cisco
S390 appliance uses the Management port only. See
Ethernet cable included in the system box. The Cisco
S390 appliance uses the Management port only. See
Step 2
Go to the Start menu and choose Control Panel.
Step 3
Double-click Network and Sharing Center.
Step 4
Click Local Area Connection and then click Properties.
Step 5
Select Internet Protocol (TCP/IP) and then click
Properties.
Properties.
Step 6
Select Use the Following IP Address.
Step 7
Enter the following changes:
–
IP Address: 192.168.42.43
–
Subnet Mask: 255.255.255.0