Примечания к выпуску для Cisco Cisco Content Switching Module with SSL
20
Release Notes for Catalyst 6500 Series Content Switching Module with SSL Software Release 2.2(x)
OL-14929-06
Open and Resolved Caveats in Software Release 2.2(3)
Resolved Caveats in Software Release 2.2(3) for CSM
Note
For a description of open CSM caveats in CSM-S software release 2.2(3), see the
This section describes resolved CSM caveats in CSM-S software release 2.2(3):
This section describes resolved caveats in CSM-S software release 4.3(3):
•
CSCsm33035
When the CSM-S starts to load balance using the default policy, and then a GET request matches a
URL under a subpolicy, the CSM-S forwards traffic to the real server without modifying the TCP
acknowledgement number.
URL under a subpolicy, the CSM-S forwards traffic to the real server without modifying the TCP
acknowledgement number.
Workaround: Disable persistent rebalance.
•
CSCsq36042
When SSL stickiness is configured on a backup server farm, the CSM-S fails to perform NAT in
some cases.
some cases.
Workaround: Disable SSL stickiness on the server farm.
•
CSCsu39853
In rare cases, the CSM-S will stop responding to the CLI but will continue to pass traffic.
Workaround: None.
•
CSCso69828
When cookie-insert is configured on the CSM-S and the server sends the FIN/ACK immediately
after its HTTP 200 OK response, the CSM-S may send some subsequent packets out of order and
with an incorrect TCP sequence number.
after its HTTP 200 OK response, the CSM-S may send some subsequent packets out of order and
with an incorrect TCP sequence number.
Workaround: None.
•
CSCsz81041
The CSM-S does not send a reset upon receiving a synchronize acknowledgement (ACK) packet
sent to a synchronize start (SYN) packet. This condition occurs in Layer 7 mode when the CSM-S
opens a connection on the backend server, and if the server responds to the SYN with an ACK that
has an invalid sequence number.
sent to a synchronize start (SYN) packet. This condition occurs in Layer 7 mode when the CSM-S
opens a connection on the backend server, and if the server responds to the SYN with an ACK that
has an invalid sequence number.
Workaround: None.
•
CSCsu92969
Configuring multiple server load balancing (SLB) policies in a particular order causes the
connection counter in a real server in the server farm to erroneously report the default maximum
connection (MAXCONN) limit of 4294967295 connections. When this condition occurs, the real
server refuses new connections.
connection counter in a real server in the server farm to erroneously report the default maximum
connection (MAXCONN) limit of 4294967295 connections. When this condition occurs, the real
server refuses new connections.
Workaround: Remove multiple SLB policies.
•
CSCsz81265
When configuring two virtual servers (Layer 3 and Layer 4) with the same virtual IP address, CSM-S
drops the ICMP request to the virtual IP address. This condition occurs when both virtual servers
are operational, and when there is no connection to the Layer 3 virtual server.
drops the ICMP request to the virtual IP address. This condition occurs when both virtual servers
are operational, and when there is no connection to the Layer 3 virtual server.
Workaround: Ensure that the Layer 3 virtual server is configured after the Layer 4 virtual server.