Руководство Пользователя для Cisco Cisco Web Security Appliance S170
2-5
AsyncOS 9.1 for Cisco Web Security Appliances User Guide
Chapter 2 Connect, Install, and Configure
System Setup Wizard
System Setup Wizard
Before You Begin:
•
Connect the Appliance to networks and devices.
•
Complete the System Setup Wizard worksheet.
.
•
If you are setting up a virtual appliance:
–
Use the
loadlicense
command to load the virtual appliance license. For complete information,
see the Cisco Content Security Virtual Appliance Installation Guide, available from
.
–
Enable the HTTP and/or HTTPS interfaces: In the command-line interface (CLI), run the
interfaceconfig
command.
•
Note that reference information for each configuration item used in the System Setup Wizard is
available at
available at
.
Warning
Only use the System Setup Wizard the first time you install the appliance or if you want to completely
overwrite the existing configuration.
overwrite the existing configuration.
Step 1
Open a browser and enter the IP address of the Web Security appliance. The first time you run the System
Setup Wizard, use the default IP address:
Setup Wizard, use the default IP address:
https://192.168.42.42:8443
-or-
http://192.168.42.42:8080
where
192.168.42.42
is the default IP address, and
8080
is the default admin port setting for HTTP,
and
8443
is default admin port for HTTPS.
Otherwise, if the appliance is currently configured, use the IP address of the M1 port.
Step 2
When the appliance login screen appears, enter the username and passphrase to access the appliance. By
default, the appliance ships with the following username and passphrase:
default, the appliance ships with the following username and passphrase:
•
Username:
admin
IPv4 Address (required)
IPv6 Address (optional)
Administrator Passphrase
Network Mask
Email System Alerts To
Hostname
(Optional) SMTP Relay Host
(Optional) Data (P1) Port
IPv4 (optional)
IPv6 Address (optional)
Network Mask
Hostname
System Setup Wizard Worksheet