Техническая Инструкция для Cisco Cisco ACE Application Control Engine Module

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Configure
      Network Diagram
      Configurations
 Verify
 Troubleshoot
 Related Information

This document provides a sample configuration for the Application Control Module (ACE) configured for
source Network Address Translation (NAT) while inserting the original client IP address in the HTTP header.
When using source NAT, the client IP address is not passed to the load balanced server. The insertion of the
Client IP address into the header allows the servers to see the IP that made the connection. The servers default
gateway points to the MSFC in the server VLAN. The only communication that needs to be load balanced
will pass through the ACE.

This sample uses two contexts:

the admin context is used for remote management and Fault Tolerant (FT) configuration

• 

the second context, C1, is used for load balancing

• 

There are no specific requirements for this document.

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to Cisco Technical Tips Conventions for more information on document conventions.