Руководство По Установке для Cisco Cisco TelePresence MX700

D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

27

Configuring IP

Your video conference system supports both IP version 4 

(IPv4) and IP version 6 (IPv6).

In both cases, the IP parameters can be assigned 

automatically by the network, or you can set everything 

manually. 

If you want to set the parameters manually please 

contact your network administrator to obtain the required 

parameters.

If an IP address is already assigned to your system, you will 

find the current IPv4 and/or IPv6 address on the System 

Information page:

Go to the 

tab and select

.

The IP address of the codec is shown in the top

section.

1.  Select IP version

Go to the 

tab and select

.

Click on 

 and then on the 

 value. Select 

which IP version to use in the 

 drop down list.

2.  Select automatic or manual IP assignment

For IPv4: Click on the 

 value and select 

or

 in the drop down list.

For IPv6: Open the 

folder and click on the 

 value. Select 

or

 in the drop 

down list.

3.  Set the IP addresses

Set the remaining IP settings according to the table to 

the right. The actions required depend on the IP version 

(

) and IP assignment method (

) you 

selected in the previous steps.

Assignment

IPStack

The IP configuration is complete.

a. Open the 

 folder; click on the 

, 

 and 

 values and enter 

the addresses in the corresponding input 

fields.

b. Open the 

 folder, and then the 

folder; click on the 

 value 

and enter the DNS server address in the 

corresponding input field.

a. Select 

or

 in the 

 drop 

down list according to your preference. 

1

 

a. Select 

or

 in the 

 drop 

down list according to your preference. 

1

b. Click on the 

 and 

values 

to enter the system IP address and the 

gateway address in the corresponding input 

fields.

1

 DHCP Options:  

      Off: All IP parameters, except the IP address and gateway, must be set manually.  
            Please refer to the Administrator Guide for your product for details about all settings.  
      On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.

Save the new value when you change a setting

Click 

to save the change, or 

 to leave without 

saving.

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration