Руководство По Обслуживанию для Cisco Cisco TelePresence MX700
Auto-registration of the endpoint
Only applicable when the CUCM is not set to mixed mode; not
applicable for endpoints connected to CUCM via Expressway.
Configuration of the CUCM for auto-registration of the
endpoint is described on this page.
Auto-registration of the TelePresence endpoint is
not possible when the CUCM is set to mixed mode
(cluster security mode).
Use the search options available on the page, or leave the
search field blank and press
Find
to list the available CUCMs.
Choose the one you would like to configure; this will take you
to the
Cisco Unified CM Configuration
page.
Enable auto-registration
Navigate to
System > Cisco Unified CM > Auto-registration
Information
.
Starting Directory Number:
Enter the lowest number in the range of directory
numbers.
Ending Directory Number:
Enter the highest number in the range of directory
numbers.
Auto-registration Disabled on this Cisco Unified
Communications Manager:
Uncheck the checkbox to enable auto-registration.
When done click
Save
and
Apply Config
.
Navigate to the
Auto-registration Information
section.
Click
Find
and choose the CUCM from the list.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Deployment Guide
D15336.01 Deployment gude for TelePresence Endpoints on CUCM, DECEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
22
Contents
Introduction
CUCM configuration
Endpoint configuration
Appendices
Contact
CUCM configuration