Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.  

www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

129

Cisco TelePresence MX700 and MX800

 Administrator Guide

NetworkServices SNMP Mode

SNMP (Simple Network Management Protocol) is used in network management systems 

to monitor network-attached devices (routers, servers, switches, projectors, etc) for 

conditions that warrant administrative attention. SNMP exposes management data in the 

form of variables on the managed systems, which describe the system configuration. These 

variables can then be queried (set to ReadOnly) and sometimes set (set to ReadWrite) by 

managing applications.

Requires user role: ADMIN
Default value: ReadOnly

Value space: Off/ReadOnly/ReadWrite

Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.

NetworkServices SNMP Host [1..3] Address

Define the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC 

program etc.), for example about system location and system contact. SNMP traps are not 

supported.

Requires user role: ADMIN
Default value: ""

Value space: String (0, 255)

A valid IPv4 address, IPv6 address or DNS name.

NetworkServices SNMP CommunityName

Define the name of the Network Services SNMP Community. SNMP Community names 

are used to authenticate SNMP requests. SNMP requests must have a password (case 

sensitive) in order to receive a response from the SNMP Agent in the codec. The default 

password is "public". If you have the Cisco TelePresence Management Suite (TMS) you 

must make sure the same SNMP Community is configured there too. NOTE: The SNMP 

Community password is case sensitive.

Requires user role: ADMIN
Default value: ""

Value space: String (0, 50)

The SNMP community name.

NetworkServices SNMP SystemContact

Define the name of the Network Services SNMP System Contact.

Requires user role: ADMIN
Default value: ""

Value space: String (0, 50)

The name of the SNMP system contact.

NetworkServices SNMP SystemLocation

Define the name of the Network Services SNMP System Location.

Requires user role: ADMIN
Default value: ""

Value space: String (0, 50)

The name of the SNMP system location.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



System settings