Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.  

www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

28

Cisco TelePresence MX700 and MX800

 Administrator Guide

In general, we recommend you to use the web interface 

to administer and maintain the video system, as 

described in this administrator guide. 

Alternatively, you can access the API of the video 

system by other methods:

•  HTTP or HTTPS (also used by the web interface)
•  SSH
•  Telnet
•  Serial interface (RS-232)

If you want more information about the different access 

methods, and how to use the API, refer to the API guide 

for the video system.

Tip
If the configuration or status is available in the API, the 

web interface setting or status translates into an API 

configuration or status as follows:

Set 

 to 

Value (web)

is the same as

xConfiguration X Y Z: Value

 (API)

Check

 status (web)

is the same as

xStatus X Y Z

 (API)

For example:

Set 

 to 

MySystem

is the same as

xConfiguration SystemUnit Name: MySystem

Check

 status

is the same as

xStatus SystemUnit Software Version

More settings and status are available in the web 

interface than in the API. 

How to administer the video system

Access method

Notes

How to enable/disable the methods

HTTP/HTTPS

• Used by the web interface of the video system
• Non-secure (HTTP) or secure (HTTPS) 

communication

• HTTP: Enabled by default 

HTTPS: Enabled by default

Restart the video system for changes 

to take effect

Telnet

• Non-secure TCP/IP connection
• Disabled by default

You do not need to restart the video 

system. It may take some time for 

changes to take effect

SSH

• Secure TCP/IP connection
• Enabled by default

You do not need to restart the video 

system. It may take some time for 

changes to take effect

Serial interface (RS-232)

• Connect to the video system with a cable. IP-

address, DNS, or a network is not required

• Enabled by default
• We recommend using the default baud rate, 

because the video system may return much 

feedback (

)

• For security reasons, you are asked to sign in by 

default (

)

Restart the video system for changes 

to take effect

If all access methods are disabled (set to 

Off), you can no longer configure the video system. You are not able to re-

enable (set to 

On) any of the access methods, and you must factory reset the video system to recover.

(page 1 of 4)

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



Introduction