Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D15119.06 MX700 and MX800 Administrator Guide TC7.3, OCTOBER 2015.  

www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved. 

137

Cisco TelePresence MX700 and MX800 

Administrator Guide

3. Set the monitor resolution and refresh rate
The codec will read the native resolution of a monitor and 

output this if possible. Typically, this will give the best 

possible picture for the connected monitor. 

If auto-detection of resolution and refresh rate fails, 

you have to set resolution manually using the 

 and 

settings. 

2. Define how to use the external monitors
Use the 

setting to define what to display on 

the external monitors.

Choose 

DualPresentationOnly to allow presentations on the 

external monitors. 

If the setting is kept at 

Single (default), the same content 

(participants and presentation) is shown on both the 

integrated and the external monitors.

Do NOT use DualPresentationOnly if no external monitor is 

connected. Presentations will fail to display.

Connecting external monitors to MX800 Single

1. Connect external monitors

i.  Switch off the system.

The power button is located directly below the codec 

connector panel.

ii.  Connect the monitors as shown in the illustration.

Use Connector 2 (HDMI); or use Connector 3 (DVI-I) for 

video and an Audio Line output for audio.

iii.  Switch on the system, and wait while the system starts 

up.

Connector 3 (DVI-I)

This connector is used for 

the integrated monitor.  

Do not disconnect!

External monitor

Codec connector panel

External monitor

Connector 2 (HDMI)

Audio Line 

outputs 

(Euroblock, 

3.5 mm)

External monitors can be used to display content or 

presentations (presented locally or received from far-end). 

You can connect two external monitors to MX800 Single. 

The same content will be displayed on both monitors. 

The codec and monitor must be connected and set up as 

described below.

For a full description of each settings, refer to the 

 chapter.

You must remove the video system’s left side cover 

to get access to the codec connector panel. The 

cover is fastened with magnets.

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

Appendices