Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014.

Cisco TelePresence MX700 and MX800

Administrator Guide

Cameras Camera [1..7] Brightness Level

Set the brightness level. Requires the Camera Brightness Mode to be set to Manual.

Requires user role: ADMIN
Value space: <1..31>

Range: Select a value from 1 to 31.

Example:

Cameras Camera 1 Brightness Level: 20

Cameras Camera [n..7] Flip

This setting applies to Camera [2..7] for single camera systems, and to HDMI [3..7] for dual

camera systems.
With Flip mode (vertical flip) you can flip the image upside down.

Requires user role: ADMIN
Value space: <Auto/Off/On>

Auto: When the camera is placed upside down the image is automatically flipped upside

down. This setting will only take effect for a camera that automatically detects which way it is

mounted.
Off: Display the video on screen the normal way.
On: When enabled the video on screen is flipped. This setting is used when a camera is

mounted upside down, but cannot automatically detect which way it is mounted.

Example:

Cameras Camera 3 Flip: Auto

Cameras Camera [n..7] Focus Mode

This setting applies to Camera [2..7] for single camera systems, and to HDMI [3..7] for dual

camera systems.
Set the camera focus mode.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: The camera will auto focus once a call is connected, as well as after moving the

camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the

right focus; then auto focus is turned off to prevent continuous focus adjustments of the

camera.
Manual: Turn the autofocus off and adjust the camera focus manually.

Example:

Cameras Camera 3 Focus Mode: Auto

Cameras Camera [1..7] Gamma Mode

This setting enables gamma corrections, and applies only to cameras which support gamma

mode. Gamma describes the nonlinear relationship between image pixels and monitor

brightness.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:

Cameras Camera [1..n] Gamma Level.

Example:

Cameras Camera 1 Gamma Mode: Auto

Cameras Camera [1..7] Gamma Level

By setting the Gamma Level you can select which gamma correction table to use. This setting

may be useful in difficult lighting conditions, where changes to the brightness setting does not

provide satisfactory results. Requires the Gamma Mode to be set to Manual.

Requires user role: ADMIN
Value space: <0..7>

Range: Select a value from 0 to 7.

Example:

Cameras Camera 1 Gamma Level: 0

Cameras Camera [1..7] IrSensor

Not applicable in this version.

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

System settings