Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D15119.01 MX700 and MX800 Administrator Guide TC7.1.2, JUNE 2014.

Cisco TelePresence MX700 and MX800

Administrator Guide

Conference settings

Conference [1..1] ActiveControl Mode

Active control is a feature that allows conference participants to administer a conference

on Cisco TelePresence Server using the video system's interfaces. Each user can see the

participant list, change video layout, disconnect participants, etc. from the interface. The active

control feature is enabled by default, provided that it is supported by the infrastructure (Cisco

Unified Communications Manager (CUCM) version 9.1.2 or newer, Cisco TelePresence Video

Communication Server (VCS) version X8.1 or newer). Change this setting if you want to disable

the active control features.

Requires user role: ADMIN
Value space: <Auto/Off>

Auto: Active control is enabled when supported by the infrastructure.
Off: Active control is disabled.

Example:

Conference ActiveControl Mode: Auto

Conference [1..1] CallProtocolIPStack

Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).

Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>

Dual: Enables both IPv4 and IPv6 for the call protocol.
IPv4: When set to IPv4, the call protocol will use IPv4.
IPv6: When set to IPv6, the call protocol will use IPv6.

Example:

Conference 1 CallProtocolIPStack: Dual

Conference [1..1] AutoAnswer Mode

Set the auto answer mode.

Requires user role: ADMIN
Value space: <Off/On>

Off: An incoming call must be answered manually by tapping the Accept key on the Touch

controller.
On: Enable auto answer to let the system automatically answer all incoming calls.

Example:

Conference 1 AutoAnswer Mode: Off

Conference [1..1] AutoAnswer Mute

Determine if the microphone shall be muted when an incoming call is automatically answered.

Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <Off/On>

Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.

Example:

Conference 1 AutoAnswer Mute: Off

Conference [1..1] AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by

the system. Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <0..50>

Range: Select a value from 0 to 50 seconds.

Example:

Conference 1 AutoAnswer Delay: 0

Conference [1..1] MicUnmuteOnDisconnect Mode

Determine if the microphones shall be unmuted automatically when all calls are disconnected.

In a meeting room or other shared resources this may be done to prepare the system for the

next user.

Requires user role: ADMIN
Value space: <Off/On>

Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.

Example:

Conference 1 MicUnmuteOnDisconnect Mode: On

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

System settings