Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.08 MX200 and MX300 Administrator Guide TC7.0, DECEMBER 2013.

Cisco TelePresence MX200 and MX300

Administrator Guide

Cameras settings

Cameras PowerLine Frequency

Applies to cameras supporting PowerLine frequency anti-flickering, i.e. Precision 1080p

cameras.

Requires user role: ADMIN
Value space: <50Hz/60Hz>

50Hz: Set to 50 Hz.
60Hz: Set to 60 Hz.

Example:

Cameras PowerLine Frequency: 50Hz

Cameras Camera [1] Backlight

This configuration turns backlight compensation on or off. Backlight compensation is useful

when there is much light behind the persons in the room. Without compensation the persons

will easily appear very dark to the far end.

Requires user role: ADMIN
Value space: <Off/On>

Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.

Example:

Cameras Camera 1 Backlight: Off

Cameras Camera [1] Brightness Mode

Set the camera brightness mode.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set using

the Cameras Camera Brightness Level setting.

Example:

Cameras Camera 1 Brightness Mode: Auto

Cameras Camera [1] Brightness Level

Set the brightness level. Requires the Camera Brightness Mode to be set to Manual.

Requires user role: ADMIN
Value space: <1..31>

Range: Select a value from 1 to 31.

Example:

Cameras Camera 1 Brightness Level: 1

Cameras Camera [1] Flip

Not applicable for this product.

Cameras Camera [1] Focus Mode

Set the camera focus mode.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: The camera will auto focus once a call is connected, as well as after moving the

camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the

right focus; then auto focus is turned off to prevent continuous focus adjustments of the

camera.
Manual: Turn the autofocus off and adjust the camera focus manually.

Example:

Cameras Camera 1 Focus Mode: Auto

Cameras Camera [1] Gamma Mode

The Gamma Mode setting enables gamma corrections. Gamma describes the nonlinear

relationship between image pixels and monitor brightness.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:

Cameras Camera [1..n] Gamma Level.

Example:

Cameras Camera 1 Gamma Mode: Auto

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings