Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.05 MX Series Administrator Guide TC6.1, APRIL 2013.

Cisco TelePresence MX Series

Administrator Guide

Conference settings

Conference [1..1] TelephonyPrefix

Enter the prefix to be used for telephony calls.

Requires user role: ADMIN
Value space: <S: 0, 80>

Format: String with a maximum of 80 characters.

Example:

Conference 1 TelephonyPrefix: "520"

Conference [1..1] AutoAnswer Mode

Set the auto answer mode.

Requires user role: ADMIN
Value space: <Off/On>

Off: An incoming call must be answered manually by tapping the Accept key on the Touch

controller.
On: Enable auto answer to let the system automatically answer all incoming calls.

Example:

Conference 1 AutoAnswer Mode: Off

Conference [1..1] AutoAnswer Mute

Determine if the microphone shall be muted when an incoming call is automatically answered.

NOTE: Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <Off/On>

Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.

Example:

Conference 1 AutoAnswer Mute: Off

Conference [1..1] AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by

the system. NOTE: Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <0..50>

Range: Select a value from 0 to 50 seconds.

Example:

Conference 1 AutoAnswer Delay: 0

Conference [1..1] MicUnmuteOnDisconnect Mode

Determine if the microphones shall be unmuted automatically when all calls are disconnected.

In a meeting room or other shared resources this may be done to prepare the system for the

next user.

Requires user role: ADMIN
Value space: <Off/On>

Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.

Example:

Conference 1 MicUnmuteOnDisconnect Mode: On

Conference [1..1] DoNotDisturb Mode

Determine if there should be an alert on incoming calls.

Requires user role: USER
Value space: <Off/On/Timed>

Off: The incoming calls will come through as normal.
On: All incoming calls will be rejected and they will be registered as missed calls. The calling

side will receive a busy signal. A message telling that Do Not Disturb is switched on will

display on the Touch controller or main display. The calls received while in Do Not Disturb

mode will be shown as missed calls.
Timed: Select this option only if using the API to switch Do Not Disturb mode on and off.

Example:

Conference 1 DoNotDisturb Mode: Off

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings