Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.05 MX Series Administrator Guide TC6.1, APRIL 2013.

Cisco TelePresence MX Series

Administrator Guide

NetworkServices SIP Mode

Determine whether the system should be able to place and receive SIP calls or not.

Requires user role: ADMIN
Value space: <Off/On>

Off: Disable the possibility to place and receive SIP calls.
On: Enable the possibility to place and receive SIP calls (default).

Example:

NetworkServices SIP Mode: On

NetworkServices SNMP Mode

SNMP (Simple Network Management Protocol) is used in network management systems to

monitor network-attached devices (routers, servers, switches, projectors, etc) for conditions

that warrant administrative attention. SNMP exposes management data in the form of variables

on the managed systems, which describe the system configuration. These variables can then

be queried (set to ReadOnly) and sometimes set (set to ReadWrite) by managing applications.

Requires user role: ADMIN
Value space: <Off/ReadOnly/ReadWrite>

Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.

Example:

NetworkServices SNMP Mode: ReadWrite

NetworkServices SNMP Host [1..3] Address

Enter the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC

program etc.), for example about system location and system contact. SNMP traps are not

supported.

Requires user role: ADMIN
Value space: <S: 0, 64>

Format: A valid IPv4 address, IPv6 address or DNS name.

Example:

NetworkServices SNMP Host 1 Address: ""

NetworkServices SNMP CommunityName

Enter the name of the Network Services SNMP Community. SNMP Community names are used

to authenticate SNMP requests. SNMP requests must have a password (case sensitive) in order

to receive a response from the SNMP Agent in the codec. The default password is "public".

If you have the Cisco TelePresence Management Suite (TMS) you must make sure the same

SNMP Community is configured there too. NOTE: The SNMP Community password is case

sensitive.

Requires user role: ADMIN
Value space: <S: 0, 50>

Format: String with a maximum of 50 characters.

Example:

NetworkServices SNMP CommunityName: "public"

NetworkServices SNMP SystemContact

Enter the name of the Network Services SNMP System Contact.

Requires user role: ADMIN
Value space: <S: 0, 50>

Format: String with a maximum of 50 characters.

Example:

NetworkServices SNMP SystemContact: ""

NetworkServices SNMP SystemLocation

Enter the name of the Network Services SNMP System Location.

Requires user role: ADMIN
Value space: <S: 0, 50>

Format: String with a maximum of 50 characters.

Example:

NetworkServices SNMP SystemLocation: ""

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings