Листовка для Cisco Cisco TelePresence MX700

Setting the call details

Some call details are configured at the endpoint.

For deployment with Cisco TelePresence Multipoint 

Switch (CTMS), the recommended value is 2500 kbps 

or higher.

The auto answer settings provisioned in Cisco Unified 

CM are ignored by the endpoint and must be set on 

the endpoint itself.

Setting the call details
If in doubt for any of the parameters below, contact your 

system administrator or your service provider.

1.  Configure the auto answering

Use the remote control and go to 

 and set to 

IPv6.

Go to the  

 section and set appropriate 

values for 

, 

 and 

.

Click 

to save the change.

2.  Configure the default call settings

Use the remote control and go to the 

 section 

and set the 

 to the appropriate value.

In Cisco UCM mode the 

 is 

automatically set to SIP, and H.323 is not supported.

Click 

to save the change.

Setting the call details
If in doubt for any of the parameters below, contact your 

system administrator or your service provider.

On the Touch controller, tap 

.

1.  Configure the auto answering

Set 

 to On or Off, and if appropriate set the 

. Tap the plus (+) or minus (-) buttons 

to increase or decrease the value. 

2.  Configure the default call settings

Choose 

 and set the 

 to the 

appropriate value. Tap the plus (+) or minus (-) buttons to 

increase or decrease the value.

In Cisco UCM mode the 

 is 

automatically set to SIP, and H.323 is not supported.

Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 

Quick Reference Guide

D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. 

www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved. 

11

Touch

OSD 

Contents

Introduction

Endpoint configuration

CUCM configuration

Setting passwords

Appendices

Endpoint configuration