Листовка для Cisco Cisco TelePresence MX700
Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0
Quick Reference Guide
D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
7
Using the Touch controller
If no menu is displayed on the Touch controller, tap the
display to wake up the system.
If the system does not wake up:
• Make sure the Touch controller is connected to the
endpoint, either directly or by the network.
• Make sure the endpoint is connected to power and
switched on.
• If the system has just been switched on, wait for a few
minutes to allow the system to start up.
• Make sure the Touch controller is properly paired with the
endpoint.
• If in doubt, read the Installation guide for your product.
You must use the Touch controller, or the remote
control with on-screen display, for the configurations
until you know your system's IP address.
Preparations
You can use the Touch controller or the remote control to
configure the system; alternatively, you can use the system's
web interface or the command line interface with API
commands.
All methods are described on the following pages.
Using the remote control
If no menu is displayed on screen, press any key on the
remote control to wake up the system.
If the system does not wake up:
• Make sure the remote control has working batteries.
• Make sure the endpoint is connected to power and
• Make sure the endpoint is connected to power and
switched on.
• If the system has just been switched on, wait for a few
minutes to allow the system to start up.
• If in doubt, read the Installation guide for your product.
You must use the Touch controller, or the remote
control with on-screen display, for the configurations
until you know your system's IP address.
Touch
OSD
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Endpoint configuration