Руководство Пользователя для Cisco Cisco Content Security Management Appliance M160

IP address and hostname of your DNS servers (not required if you want to use Internet root servers)

Hostname or IP address of your NTP servers (not required if you want to manually set system time)

For more information, see 

If you are running a firewall on your network between the Internet and the content security appliance, it 
may be necessary to open specific ports for the appliance to work properly. For more information on 
firewalls, see 

Always use the same IP address on the Security Management appliance for receiving and sending email 
messages to the Email Security appliances. For an explanation, see information about Mail Flow in the 
documentation for your Email Security appliance. 

Note that IPv6 is not supported for communication between the Cisco Content Security Management 
appliance and the appliances it manages. 

Use the following table to gather information about system setup. You will need this information at hand 
while running the System Setup Wizard. 

See the 

 for detailed information about network and 

IP addresses.

1

Notifications 

Email address where system alerts are sent:

2

System Time

NTP Server (IP address or hostname): 

3

Admin Password

Choose a new password for the “admin” account: 

4

AutoSupport

Enable AutoSupport?___ Yes  ___ No 

5

Hostname

Fully qualified hostname of the Security Management 
appliance:

6

Interface / IP Address

IP address: 

Netmask: