Примечания к выпуску для Cisco Cisco IOS Software Release 12.0 S
2369
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(11)S6
Wide-Area Networking
•
CSCdr43764
Extracting 64-bit Simple Network Management Protocol (SNMP) counters for the Frame Relay
interface on a Packet-over-SONET (POS) interface might not work. This condition applies to both
the relevant IF-MIB counters and the Cisco-specific 2 x 32-bit counters in
CISCO-C12000-IF-HC-COUNTERS-MIB and relates only to the Frame Relay 64-pit permanent
virtual connection (PVC) counts when a Frame Relay encapsulated interface is added to a POS
interface. The main POS interface counters are not affected and continue to function properly.
interface on a Packet-over-SONET (POS) interface might not work. This condition applies to both
the relevant IF-MIB counters and the Cisco-specific 2 x 32-bit counters in
CISCO-C12000-IF-HC-COUNTERS-MIB and relates only to the Frame Relay 64-pit permanent
virtual connection (PVC) counts when a Frame Relay encapsulated interface is added to a POS
interface. The main POS interface counters are not affected and continue to function properly.
Workaround: Upgrade to an image that contains this patch.
Resolved Caveats—Cisco IOS Release 12.0(11)S6
Cisco IOS Release 12.0(11)S6 is a rebuild of Cisco IOS Release 12.0(11)S. All the caveats listed in this
section are resolved in Cisco IOS Release 12.0(11)S6 but may be open in previous releases.
section are resolved in Cisco IOS Release 12.0(11)S6 but may be open in previous releases.
•
CSCdr70415
When you remove the configuration for Multiprotocol Label Switching (MPLS) traffic engineering
(TE) tunnels on a Cisco router that is running Cisco IOS Release 12.0 S, you may see the shortest
path first (SPF) algorithm under the Open Shortest Path First (OSPF) protocol start running every
10 seconds on all routers in the area where the configuration was removed.
(TE) tunnels on a Cisco router that is running Cisco IOS Release 12.0 S, you may see the shortest
path first (SPF) algorithm under the Open Shortest Path First (OSPF) protocol start running every
10 seconds on all routers in the area where the configuration was removed.
Workaround: Stop the SPF recalculations by restarting OSPF on all routers in the area by using the
following set of commands:
following set of commands:
–
no router ospf X (where X is your process number for OSPF)
–
config memory
•
CSCdr76940
The following error message may appear on a Cisco router console:
%LC-3-PSALOADSHARE MPLS loadsharing inconsistency for 0.0.0.0/0
No problems are related to this message. If you see any Multiprotocol Label Switching (MPLS)
load-sharing forwarding problems at the time the error message is emitted, contact your technical
support representative. There is no workaround.
load-sharing forwarding problems at the time the error message is emitted, contact your technical
support representative. There is no workaround.
•
CSCdw65903
An error can occur with management protocol processing. Please use the following URL for further
information:
information: