Руководство По Устранению Ошибки для Cisco Cisco Security Manager 4.0
Contents
Introduction
Prerequisites
Requirements
Components Used
Problem: Few CSM services fail to start automatically when it is upgraded to 4.8 or later versions.
Symptoms
View Permission Changes
Trigger of the Issue
Solution
Related information
Introduction
This document describes the behavior change in
Cisco Security Manager
(CSM) services and the
required permissions to execute them on CSM 4.8 or later releases.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
Problem: Few CSM services fail to start automatically when
it is upgraded to 4.8 or later versions.
it is upgraded to 4.8 or later versions.
Symptoms
1. Log in to Configuration Manager, it only shows a blank page under Device view tab, none of
the devices are visible, as shown in the image.
the devices are visible, as shown in the image.