Примечания к выпуску для Cisco Cisco IOS XE 3.5E

    Added ct5760-platform.SPA.03.03.00SE.pkg

    Added ct5760-wcm.SPA.10.1.100.0.pkg

[1]: Creating pending provisioning file

[1]: Finished installing software. New software will load on reboot.

[1]: Committing provisioning file

 

[1]: Do you want to proceed with reload? [yes/no]: 

The Cisco 5700 Series WLC is the first Cisco IOS-based controller built with smart ASIC for next generation unified wireless 
architectures. The Cisco 5700 Series WLC can be deployed both as a Mobility Controller (MC) in Converged Access solutions 
and as a Centralized Controller.

For more information about the features, see the product data sheet at this URL:

A switch stack containing a mix of Catalyst 3850 and Catalyst 3650 switches is not supported.

Although visible in the CLI, the following commands are not supported:

collect flow username 

authorize-lsc-ap (CSCui93659) 

show platform qos xxx (CSCug09112)

The following features are not supported in Cisco IOS XE Release 3.3.0SE: 

Outdoor Access Points

Wired Guest Access

Wired Guest Access is supported is the Cisco IOS XE Release 3.3.1SE.

Mesh, FlexConnect, and Office Extend Access Point deployment

Flex Links are not supported. We recommend that you use spanning tree protocol (STP) as the alternative.

Restrictions for Cisco TrustSec: 

Cisco TrustSec can be configured only on physical interfaces, not on logical interfaces.

Cisco TrustSec for IPv6 is not supported.

Dynamic binding of IP-SGT is not supported for hosts on Layer 3 physical routed interfaces because the IP Device 
Tracking feature for Layer 3 physical interfaces is not supported.

Cisco TrustSec cannot be configured on a pure bridging domain with IPSG feature enabled. You must either enable IP 
routing or disable the IPSG feature in the bridging domain.