Листовка для Cisco Cisco ASA 5510 Adaptive Security Appliance
14-42
Cisco ASA Series 명령 참조 , S 명령
14장 show uauth through show xlate 명령
show version
No Payload Encryption 모델이 있는 경우에는 라이센스를 볼 때 VPN 및 유니파이드 커뮤니케이션
라이센스가 나열되지 않습니다.
라이센스가 나열되지 않습니다.
ASA 5505에 대한 총 VPN 피어 수의 경우 모든 유형의 총 통합 VPN 세션 수는 라이센스에 따라 달
라집니다. AnyConnect Essentials를 사용하는 경우 총 세션 수는 모델의 최대값인 25입니다.
AnyConnect Premium을 사용하는 경우 총 세션 수는 AnyConnect Premium 값과 Other VPN 값을 더
한 값이지만 25개 세션을 초과할 수 없습니다. Other VPN 값이 모든 VPN 세션에 대한 모델 제한과
동일한 다른 모델과 달리, ASA 5505는 Other VPN 값이 모델 제한보다 낮으므로 총 값은
AnyConnect Premium 라이센스에 따라 다를 수 있습니다.
라집니다. AnyConnect Essentials를 사용하는 경우 총 세션 수는 모델의 최대값인 25입니다.
AnyConnect Premium을 사용하는 경우 총 세션 수는 AnyConnect Premium 값과 Other VPN 값을 더
한 값이지만 25개 세션을 초과할 수 없습니다. Other VPN 값이 모든 VPN 세션에 대한 모델 제한과
동일한 다른 모델과 달리, ASA 5505는 Other VPN 값이 모델 제한보다 낮으므로 총 값은
AnyConnect Premium 라이센스에 따라 다를 수 있습니다.
예
다음은 소프트웨어 버전, 하드웨어 컨피그레이션, 라이센스 키 및 관련 가동 시간 정보를 표시하는
show version
명령의 샘플 출력입니다. 상태 저장 대체작동이 구성된 환경에서는 대체작동 클러스
터 가동 시간을 나타내는 추가 줄이 표시됩니다. 대체작동이 구성되어 있지 않으면 이 줄이 표시되
지 않습니다. 다음 화면에서는 최소 메모리 필요 조건에 대한 경고 메시지를 보여 줍니다.
지 않습니다. 다음 화면에서는 최소 메모리 필요 조건에 대한 경고 메시지를 보여 줍니다.
*************************************************************************
** **
** *** WARNING *** WARNING *** WARNING *** WARNING *** WARNING *** **
** **
** ----> Minimum Memory Requirements NOT Met! <---- **
** **
** Installed RAM: 512 MB **
** Required RAM: 2048 MB **
** Upgrade part#: ASA5520-MEM-2GB= **
** **
** This ASA does not meet the minimum memory requirements needed to **
** run this image. Please install additional memory (part number **
** listed above) or downgrade to ASA version 8.2 or earlier. **
** Continuing to run without a memory upgrade is unsupported, and **
** critical system features will not function properly. **
** **
*************************************************************************
Cisco Adaptive Security Appliance Software Version 8.4(1)
Device Manager Version 6.4(1)
Compiled on Thu 20-Jan-12 04:05 by builders
System image file is "disk0:/cdisk.bin"
Config file at boot was "disk0:/tomm_backup.cfg"
asa3 up 3 days 3 hours
Hardware: ASA5520, 512 MB RAM, CPU Pentium 4 Celeron 2000 MHz
Internal ATA Compact Flash, 64MB
Slot 1: ATA Compact Flash, 128MB
BIOS Flash AT49LW080 @ 0xfff00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03
IPsec microcode : CNlite-MC-IPSECm-MAIN-2.06
0: Ext: GigabitEthernet0/0 : address is 0013.c480.82ce, irq 9
1: Ext: GigabitEthernet0/1 : address is 0013.c480.82cf, irq 9
2: Ext: GigabitEthernet0/2 : address is 0013.c480.82d0, irq 9
3: Ext: GigabitEthernet0/3 : address is 0013.c480.82d1, irq 9
4: Ext: Management0/0 : address is 0013.c480.82cd, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5