Руководство По Установке для Cisco Cisco Aironet 1530i Outdoor Access Point
15
Note
The FCC limits the amount of power this device can transmit. Power transmitted is a
combination of the amplification of the signal and the antenna gain. The access point has been
designed to operate with the Cisco provided antennas.
combination of the amplification of the signal and the antenna gain. The access point has been
designed to operate with the Cisco provided antennas.
Power
Note
For detailed information on the power options available for the 1530 series access points, see
the Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide.
the Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide.
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Statement 1074
Warning
This equipment must be externally grounded using a customer-supplied ground wire
before power is applied. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 366
before power is applied. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 366
Warning
Do not work on the system or connect or disconnect cables during periods of lightning
activity. Statement 1001
activity. Statement 1001
The 1532E access point supports these power sources:
•
DC power—24- 57 VDC
•
Power-over-Ethernet (PoE)
Caution
Do not place the power injector in an unprotected outdoor environment because water
could get into the power injector and cause a short circuit and possible fire.
could get into the power injector and cause a short circuit and possible fire.
Warning
Connect the unit only to DC power source that complies with the Safety Extra-Low
Voltage (SELV) requirements in IEC 60950 based safety standards Statement 1033
Voltage (SELV) requirements in IEC 60950 based safety standards Statement 1033