Техническая Инструкция для Cisco Cisco ASA for Nexus 1000V Series Switch

ASA 8.x Manually Install 3rd Party Vendor
Certificates for use with WebVPN Configuration
Example

Document ID: 98596

Contents

Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Step 1. Verify that the Date, Time, and Time Zone Values are Accurate
Step 2. Generate a Certificate Signing Request
Step 3. Authenticate the Trustpoint
Step 4. Install the Certificate
Step 5. Configure WebVPN to Use the Newly Installed Certificate
Verify
View Installed Certificates
Verify Installed Certificate for WebVPN with a Web Browser
Commands
Troubleshoot
Related Information

Introduction

This configuration example describes how to manually install a 3rd party vendor digital certificate on the
ASA for use with WebVPN. A Verisign Trial Certificate is used in this example. Each step contains the
ASDM application procedure and a CLI example.

Prerequisites

Requirements

This document requires that you have access to a certificate authority (CA) for certificate enrollment.
Examples of 3rd party CA vendors include, but are not limited to, Baltimore, Cisco, Entrust, Geotrust,
Godaddy, iPlanet/Netscape, Microsoft, RSA, Thawte, and VeriSign.

Components Used

This document uses an ASA 5510 that runs software version 8.0(2) and ASDM version 6.0(2).

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.