Техническая Инструкция для Cisco Cisco ASA for Nexus 1000V Series Switch

Contributed by Gustavo Medina and Hamzah Kardame, Cisco TAC
Engineers.
Jun 16, 2014

Introduction
Prerequisites
     Requirements
     Components Used
Background Information
Configure
     Add a New Dynamic Entry
Verify
Troubleshoot

This document describes how to configure the Cisco Adaptive Security Appliance (ASA) in order to allow a
remote VPN client connection from a Lan−to−Lan (L2L) peer address.

Cisco recommends that you have knowledge of these topics:

Cisco ASA

• 

Remote Access VPNs

• 

LAN−to−LAN VPNs

• 

The information in this document is based on the Cisco 5520 Series ASA that runs software Version 8.4(7).

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Although it is not common to encounter a scenario where a VPN client attempts to establish a connection
through a L2L tunnel, administrators might want to assign specific privileges or access restrictions to certain
remote users and instruct them to use the software client when access to these resources is required.