Техническая Инструкция для Cisco Cisco ASA for Nexus 1000V Series Switch
ASA 9.x EIGRP Configuration Example
Document ID: 91264
Contributed by Dinkar Sharma, Magnus Mortensen, and Prashant Joshi,
Cisco TAC Engineers.
Cisco TAC Engineers.
May 13, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Guidelines and Limitations
EIGRP and Failover
Configure
Network Diagram
ASDM Configuration
Configure EIGRP Authentication
EIGRP Route Filtering
Verify
Configurations
Cisco ASA CLI Configuration
Cisco IOS Router (R1) CLI Configuration
Verify
Packet Flow
Troubleshoot
Troubleshooting Commands
EIGRP Neighborship Goes Down with Syslogs ASA−5−336010
Prerequisites
Requirements
Components Used
Background Information
Guidelines and Limitations
EIGRP and Failover
Configure
Network Diagram
ASDM Configuration
Configure EIGRP Authentication
EIGRP Route Filtering
Verify
Configurations
Cisco ASA CLI Configuration
Cisco IOS Router (R1) CLI Configuration
Verify
Packet Flow
Troubleshoot
Troubleshooting Commands
EIGRP Neighborship Goes Down with Syslogs ASA−5−336010
Introduction
This document describes how to configure the Cisco Adaptive Security Appliance (ASA) in order to learn
routes through the Enhanced Interior Gateway Routing Protocol (EIGRP), which is supported in ASA
Software Version 9.x and later, and perform authentication.
routes through the Enhanced Interior Gateway Routing Protocol (EIGRP), which is supported in ASA
Software Version 9.x and later, and perform authentication.
Prerequisites
Requirements
Cisco requires that you meet these conditions before you attempt this configuration:
Cisco ASA must run Version 9.x or later.
•
EIGRP must be in single−context mode, because it is not supported in multi−context mode.
•