Техническая Инструкция для Cisco Cisco ASA for Nexus 1000V Series Switch
ASA 8.4(x) Connects a Single Internal Network to
the Internet Configuration Example
the Internet Configuration Example
Document ID: 112998
Contributed by Dinkar Sharma, David Houck, and Magnus Mortensen,
Cisco TAC Engineers.
Jun 20, 2014
Cisco TAC Engineers.
Jun 20, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Network Diagram
ASA 8.4 Configuration
Router Configuration
ASA 8.4 and Later Configuration
Verify
Connection
Prerequisites
Requirements
Components Used
Configure
Network Diagram
ASA 8.4 Configuration
Router Configuration
ASA 8.4 and Later Configuration
Verify
Connection
Syslog
NAT Translations (Xlate)
Troubleshoot
Packet−Tracer
Capture
Related Information
Troubleshoot
Packet−Tracer
Capture
Related Information
Introduction
This document describes how to set up the Cisco Adaptive Security Appliance (ASA) with Version 8.4(1) for
use on a single internal network.
use on a single internal network.
Refer to PIX/ASA: Connecting Single Internal Network with Internet Configuration Example for the same
configuration on the ASA with Versions 8.2 and earlier.
configuration on the ASA with Versions 8.2 and earlier.
Prerequisites
Requirements
There are no specific prerequisites for this document.
Components Used
The information in this document is based on the ASA with Version 8.4(1).
The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.