Техническая Инструкция для Cisco Cisco WT2750 Multipoint Broadband Wireless System
Procedure for Copying and Loading Microcode for
Point−to−Multipoint Systems
Point−to−Multipoint Systems
Document ID: 5116
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Procedure
Related Information
Prerequisites
Requirements
Components Used
Conventions
Procedure
Related Information
Introduction
This document demonstrates the procedure to properly copy and load the microcode for the
point−to−multipoint (P2MP) system. Make a note of the default location for this microcode so that you can
load it properly if placed elsewhere.
point−to−multipoint (P2MP) system. Make a note of the default location for this microcode so that you can
load it properly if placed elsewhere.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Wireless networks
•
Command−line usage
•
Ensure that you have privileged EXEC ("enabled") access on the router you want to examine.
Components Used
The information in this document is based on these software and hardware versions:
The uBR7223, uBR7246 and uBR7246VXR products
•
Any version of Cisco IOS® Software that supports Fixed Wireless P2MP
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Procedure