Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller

If your network is operating with 1522s or you plan to install 1522s in your network, you must set the 
boot variable on the 1522 before upgrading from release 4.1.190.5 to 4.1.191.24M or from 4.1.191.24M 
to 4.1.192.35M. This ensures that the 1522 joins correctly (CSCsl70218).

A GUI and CLI message warning users not to select global as the backhaul setting is missing in release 
4.1.192.35M. This message was present in 4.1.191.24M. The same warning applies even though it is not 
shown in the current release. Configuring the ‘global’ setting on a backhaul setting often causes 
unpredictable behavior and might cause network problems with the mesh access points. Therefore, do 
not configure the global setting on mesh access point backhauls using the CLI and GUI (CSCso21425).

Refer to the Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide for 
details on the physical installation and initial configuration of the mesh access points at: 

Refer to “Monitoring Wireless Devices” (Chapter 6) in the Cisco Wireless Control System Configuration 
Guide, Release 5.0 for details on monitoring the mesh network (access points, links, statistics, alarms) 
at:

Refer to “Running Reports” (Chapter 14) in the Cisco Wireless Control System Configuration Guide, 
Release 5.0 for more details on mesh reports at: 

These release notes contain the following sections: