Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller
10
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.1.181.0
OL-31336-01
New and Changed Information
AP1510 Interoperability with Cisco 3200 MAR in Public-Safety Networks
You can configure the Cisco AP1510 to interoperate with the Cisco 3200 Series Wireless Mobile Access
Router (MAR) on the public-safety channel (4.9 GHz) to integrate data collected from in-vehicle
deployments such as police cars into the overall wireless infrastructure. Follow these guidelines for the
AP1510 and Cisco 3200 MAR to interoperate on the public-safety network:
Router (MAR) on the public-safety channel (4.9 GHz) to integrate data collected from in-vehicle
deployments such as police cars into the overall wireless infrastructure. Follow these guidelines for the
AP1510 and Cisco 3200 MAR to interoperate on the public-safety network:
•
The Cisco 3200 MAR must run Cisco IOS Software Release 12.3(2)JK3, and the AP1510 must run
controller software release 4.1.181.0.
controller software release 4.1.181.0.
•
Client access must be enabled on the backhaul to use the 4.9-GHz band for client traffic.
•
Public safety must be enabled globally on all MAPs in the mesh network.
•
When using the CLI, the 802.11a radio must be disabled before configuring channels and then
re-enabled.
re-enabled.
•
The channel number assignment on the AP1510 and Cisco 3200 MAR radio interfaces must match.
–
Channels 20 (4950 MHz) and 26 (4980 MHz) are used for client access. This configuration
change is made on the controller. No changes are made to the access point configuration.
change is made on the controller. No changes are made to the access point configuration.
–
Channel assignments are made only to the RAP. Updates to the MAP are propagated by the RAP.
–
To ensure backward compatibility with controller software releases 4.0 and 4.1.171.0, channels
190 and 196 are still used for the backhaul and client access.
190 and 196 are still used for the backhaul and client access.
Using the GUI to Enable AP1510 Association with the Cisco 3200 MAR
Follow these steps to enable the AP1510 to associate with the Cisco 3200 MAR using the GUI.
Step 1
Click Wireless > Mesh to access the Mesh page.
Step 2
Check the Backhaul Client Access check box to allow wireless client association over the 802.11a radio
and click Apply.
and click Apply.
Step 3
When you are prompted to allow a reboot of all mesh access points in order to enable backhaul client
access, click OK.
access, click OK.
Step 4
On the controller CLI, enter this command to enable public-safety:
config mesh public-safety enable all
Step 5
On the controller GUI, click Wireless > Access Points > Radios > 802.11a/n. The 802.11a/n Radios page
appears.
appears.
Step 6
Hover your cursor over the blue drop-down arrow for the desired RAP and choose Configure. The
802.11a/n Cisco APs > Configure page appears.
802.11a/n Cisco APs > Configure page appears.
Step 7
Under RF Backhaul Channel Assignment, choose Custom for the Assignment Method and either
channel 20 or 26 from the Custom drop-down menu.
channel 20 or 26 from the Custom drop-down menu.
Step 8
Click Apply to commit your changes.
Step 9
Click Save Configuration to save your changes.