Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller
13
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.1.181.0
OL-31336-01
New and Changed Information
LED Verification on 1500 Series Access Points
You can attach an LED indicator to the Power over Ethernet (PoE) connector of AC-powered Cisco
Aironet 1505 and 1510 Access Points to verify that power is on. A steady green color indicates that the
access point is receiving power and that LWAPP is connected and ready to serve clients. You might
notice a blinking green light between the initial and final steady green light as the LED confirms LWAPP
connectivity.
Aironet 1505 and 1510 Access Points to verify that power is on. A steady green color indicates that the
access point is receiving power and that LWAPP is connected and ready to serve clients. You might
notice a blinking green light between the initial and final steady green light as the LED confirms LWAPP
connectivity.
Note
1500 series access points with a serial number of WCN10160121 or greater support the use of the LED
indicator.
indicator.
Note
Do not install the LED indicator if the access point has an Ethernet connection to the network.
For details about installing the LED indicator, see the Cisco Aironet Series 1500 Access Point LED
Indicator Installation Instructions at this URL:
Indicator Installation Instructions at this URL:
Mesh Changes
These changes in mesh functionality have been added to controller software release 4.1.181.0.
•
The ability to enable or disable the MAC filter list has been removed from both the controller GUI
and CLI.
and CLI.
•
Because controller software release 4.1 does not support an external AAA server for mesh access
points, local authentication and RADIUS server support should always be enabled. Therefore, the
following CLI commands are no longer supported:
points, local authentication and RADIUS server support should always be enabled. Therefore, the
following CLI commands are no longer supported:
config mesh local-auth disable
config mesh radius-server
•
The show mesh env {summary | Cisco_AP} CLI command now provides battery details, including
charge, power, serial number, temperature, version, and voltage. Here is a sample output:
charge, power, serial number, temperature, version, and voltage. Here is a sample output:
AP Name : ap:60:6b:30
AP Model : OAP1500
AP Role : MeshAP
Temperature: 33 C, 91 F
Heater : OFF
Ethernet : UP
Battery S/W version : 01.02a
Battery Serial Number : 0638F9500006
WARNING: Replace battery
Battery Input Voltage : 120.0 V
Battery Output Voltage: 55.1 V
Battery Output Power : 12.2 W
Battery Voltage : 52.5 V
Battery Temperature : 23 C 73 F
Battery Charge : 100.000 %