Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller
25
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.1.181.0
OL-31336-01
Important Notes
Using the Backup Image
The controller bootloader (ppcboot) stores a copy of the active primary image and the backup image. If
the primary image becomes corrupted, you can use the bootloader to boot with the backup image.
the primary image becomes corrupted, you can use the bootloader to boot with the backup image.
With the backup image stored before rebooting, be sure to choose Option 4: Change Active Boot Image
from the boot menu to set the backup image as the active boot image. Otherwise, when the controller
resets, it again boots off the corrupted primary image.
from the boot menu to set the backup image as the active boot image. Otherwise, when the controller
resets, it again boots off the corrupted primary image.
After the controller boots, the active boot image can be changed to the backup image using the config
boot backup command.
boot backup command.
Home Page Retains Web Authentication Login with IE 5.x
Because of a caching problem in the Internet Explorer 5.x browser, the home page retains the web
authentication login. To correct this problem, clear the history or upgrade your workstation to Internet
Explorer 6.x.
authentication login. To correct this problem, clear the history or upgrade your workstation to Internet
Explorer 6.x.
Rogue Location Discovery Protocol (RLDP)
Enabling RLDP may cause access points connected to the controller to lose connectivity with their
clients for up to 30 seconds.
clients for up to 30 seconds.
Ad-Hoc Rogue Containment
Client card implementations may mitigate the effectiveness of ad-hoc containment.
Changing the Default Values of SNMP Community Strings
The controller has commonly known default values of “public” and “private” for the read-only and
read-write SNMP community strings. Using these standard values presents a security risk. Therefore,
Cisco strongly advises that you change these values. Refer to the Cisco Wireless LAN Controller
Configuration Guide, Release 4.1 for configuration instructions.
read-write SNMP community strings. Using these standard values presents a security risk. Therefore,
Cisco strongly advises that you change these values. Refer to the Cisco Wireless LAN Controller
Configuration Guide, Release 4.1 for configuration instructions.
Changing the Default Values for SNMP v3 Users
The controller uses a default value of “default” for the username, authentication password, and privacy
password for SNMP v3 users. Using these standard values presents a security risk. Therefore, Cisco
strongly advises that you change these values. Refer to the Cisco Wireless LAN Controller Configuration
Guide, Release 4.1 for configuration instructions.
password for SNMP v3 users. Using these standard values presents a security risk. Therefore, Cisco
strongly advises that you change these values. Refer to the Cisco Wireless LAN Controller Configuration
Guide, Release 4.1 for configuration instructions.
Note
SNMP v3 is time sensitive. Make sure that you have configured the correct time and time zone on your
controller.
controller.